SISTEM MONITORING NIRKABEL VOLUME CAIRAN INFUS PASIEN MENGGUNAKAN MIKROKONTROLER ATMEGA328
Abstract Views : 342 / Downloads Count: 367DOI:
https://doi.org/10.31949/infotech.v9i1.5255Keywords:
Monitoring, nirkabel, mikrokontroller, infusAbstract
The hospital is a health facility that provides diagnostic and therapeutic services to patients for various diseases and mental health problems, both surgical and non-surgical. It is a place to get healing for an illness that is suffered. At present medical devices need attention to get the right results when treating patients, of course, increasing technological sophistication. One of the common medical procedures performed on patients is to administer drugs via intravenous injection. Intravenous injection or infusion is done by inserting fluids into a vein through a needle to replace fluids or nutrients that are lost from the body. However, because the number of patients is large and each patient may require a different infusion, the nurse must check each infusion individually in each room. To overcome this problem, a tool was created that can automatically monitor the volume of infusion fluids in each patient room, so that nurses can monitor patient infusions from one place and reduce the need to check manually. The research method used is to manufacture the tool and then conduct an experiment, namely testing the tool and analyzing the results of the tool test.
Downloads
References
Absony, “Monitoring Volume Cairan Infus Pasien Menggunakan Bahasa Pemrograman Visual Basic,”2010.
A. Sifa Fauziyyah, “rancang bangun alat ukur jumlah tetes dan volume sisa cairan infus dengan warning system pada sistem monitoring cairan infus berbasis Arduino,” Pillar Phys., vol. 12, hal. 25–30, 2019.
S. Megawati, S. A. Widiyastuti, dan N. Wati Indah, “Monitoring infus menggunakan sensor load cell,” 2019.
G. Priyandoko, “Rancang bangun sistem portable monitoring infus berbasis internet of things,” JJEEE Jambura J. Electr. Electron. Eng., vol. 3, hal. 56–61, 2021.
Aditya Rosyady Phisca, Santa Sanitya Sukarjiana Aditya, Umy Habibah Nurina, Ihsana Nuni, Baswara Ahmad Raditya Cahya, Dinata Widya Rahayu, Sulistiawan Dedik, “Monitoring Cairan Infus Menggunakan Load Cell Berbasis Internet of Things (IoT),” Techné Jurnal Ilmiah Elektroteknika Vol. 22 No. 1 April 2023
Yoice R. Putung, Donald Noya, Ventje F. Aror, Josephin Sundah, Muchdar Dg. Patabo, “Desain Pemantauan Cairan Infus Dengan Mikrokontroler Arduino Nano,” Prosiding Seminar Nasional Produk Terapan Unggulan Vokasi Politeknik Negeri Manado Vol.1 No.2 Tahun 2022
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2023 INFOTECH journal
![Creative Commons License](http://i.creativecommons.org/l/by-nc-sa/4.0/88x31.png)
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.